ASTM F436M PDF

pieces, circular washers, hot-dip galvanized, 24 mm, Type 1 ASTM F. M, dated ______. (2) pieces, beveled washers, 22 mm, Type 3,. ASTM, F M. Designation: F M – 93 (Reapproved ) METRIC. Standard Specification for. Hardened Steel Washers [Metric]’ This standard is issued under the fixed. Designation: F M – 93 (Reapproved ) METRIC Standard Specification for ‘This specification is under the jurisdiction of ASTM Committee F on.

Author: Faugrel Taukinos
Country: Indonesia
Language: English (Spanish)
Genre: Science
Published (Last): 3 September 2007
Pages: 308
PDF File Size: 11.69 Mb
ePub File Size: 17.4 Mb
ISBN: 201-8-76206-854-7
Downloads: 15926
Price: Free* [*Free Regsitration Required]
Uploader: Dishakar

Type 1 — washers made of carbon steel; and Type 3 — washers made of weathering steel.

Hardened Washers

Note 1—This specification is the metric counterpart of Specification F Link to Active This link will always route to the current Active version of the standard. This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 asstm M Moreover, the styles of washers covered here are: Link to Active This link will v436m route to the current Active version of the standard.

Historical Version s – view previous versions of standard. Each type and style of washer shall be suitably sampled, and should conform to specified values of chemical composition, Rockwell hardness, inside and outside diameter, thickness, and clipped width.

  ECONOMICS BY GERARDO P.SICAT PDF

ASTM FM – 11 Standard Specification for Hardened Steel Washers [Metric] (Withdrawn )

It is informational only astj not an official part of the standard; the full text of the standard itself must be referred to for its use and application. The atmospheric corrosion resistance of these steels is substantially better than that of carbon steel with or without copper addition. The types of washers covered here are: These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally zstm externally threaded fasteners.

ff436m These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally and externally threaded fasteners. When properly exposed to the atmosphere, these steels can be used bare uncoated for many applications. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Referenced Documents purchase separately The documents listed below are referenced within the subject standard f436k are not provided as part of the standard.

  ELECTRICAL TECHNOLOGY VOL.2 BY B.L.THAREJA PDF

Combining values from the two systems may result in non-conformance with the standard. This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal asstm diameters of M12 through M Stay on Page Continue to Compass.

Steels to be used to manufacture the washers shall be produced by the open-hearth, basic-oxygen, or electric-furnace process. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This abstract is a brief summary of the referenced standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

WASHER FM SILVER ZINC ASTM 10MM ( )

Work Item s – proposed revisions of this standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. No other units of measurement are included in this standard.