FBI XL2T PROGRAM PDF

Introduction The XL-2T is a state of the art microprocessor-based control/ communicator. The system features seven (7) fully programmable zones. Programming. XL-2T. Security System. Installation and Setup Guide. STAY. INSTANT. ACYLB. READY APPENDIX D – SYSTEM PROGRAMMING WORKSHEET. Example: To program phone number enter 1#8#0#0# etc. Exit Program STAY. Default Panel Short “EEPROM RESET” pins on panel and power up system.

Author: Kami Grocage
Country: Cape Verde
Language: English (Spanish)
Genre: Environment
Published (Last): 21 August 2016
Pages: 249
PDF File Size: 1.65 Mb
ePub File Size: 7.34 Mb
ISBN: 767-9-33334-578-9
Downloads: 5450
Price: Free* [*Free Regsitration Required]
Uploader: Grole

Each condition will cause these LEDs to operate differently as follows: Programming can be performed through any of the compatible keypads or the system can be porgram and downloaded remotely using the EZ-Mate PC Downloader Software. Don’t show me this message again.

Trigger 1 must be selected for smoke detector power reset for this feature to active. Good Day I had a four digit user code, but the last digit was lost. Enter the digit from the table below. The system must be in ready mode. Page 40 Section 5 – System Operations If a user code is not required to set the time, then enter: At the moment telephone line seizure occurs, the Telco Fbl is momentary connected to earth ground to access dial tone.

  AMERICA B.C.BY BARRY FELL PDF

FBI XL-2 Program Sheet

See the following diagram: Refer to the Installation Instructions for hookup information. The system features seven 7 fully programmable zones. A-2 progeam or 4x Got it, continue to print. Some new features have been added and others have been modified. I want to change this 3 digit code to a new 4 digit code, but with no success.

Programming Questions This topic defines the programming questions and the values for each question. The rear plastic mounting plate is not used for recessed installations. Next, enter the desired account number each digit followed by the key. Section 5 – System Fni If a user code is not required to set the time, then enter: Keypad Sounder Section 5 – System Operations Keypad Sounder The sounder or loudspeaker housed inside the keypad, emits annunciates sounds according to the condition of the security system.

FBII XL-2T Installation And Setup Manual

System ready to be armed System not ready to be armed With this device some systems can obtain dial tone in areas which do not automatically provide dial tone. There are 36 total questions, with multiple data entry locations.

Quick Arming allows arming the system without entry progrwm a user code and will report as proyram Question 32, L1 – Bypass Code Replacement microprocessors are available through Technical Support or Customer Service.

  CONCRETE TECHNOLOGY BY M L GAMBHIR PDF

The auto arm time represents the time of day that the area will automatically arm if it is not already armed. Select the desired location between wall studs for mounting the keypad. To print the manual completely, please, download it. The purpose of this manual is to give you a brief overview of the XL-2T control panel, and provide instructions for installing a basic system.

Page 23 Fire Trouble is reported to the CS if enabled program question 32, location 3. I pressed the code button ready light did not flashthen pressed both 7 and 9 at same time, to reset master code to The restore code will also be reported if the system is disarmed during an alarm.

FBI XL-2T Turbo Program Sheet

Create an opening and mount a standard double-gang box. Comments to this Manuals Your Name. So now i activate the alarm on only a 3 digit code and it is working like that.

The keypads can be surface mounted or flush mounted as described cbi. LCD display keypads will indicate the following message: The Extended Reporting Format: